Case K40 Spezifikationen PDF herunterladen (Seite 119)

S-K40 Remote Control

Software Manual 1161.8209.42 - 04 103

Bit No Meaning

0 LIMit 1 FAIL

This bit is set limit line 1 is violated

1 LIMit 2FAIL

This bit is set limit line 2 is violated

2 LIMit 3 FAIL

This bit is set limit line 3 is violated

3 LIMit 4 FAIL

This bit is set limit line 4 is violated.

4 LIMit 5 FAIL

This bit is set limit line 5 is violated.

5 LIMit 6 FAIL

This bit is set limit line 6 is violated.

6 LIMit 7 FAIL

This bit is set limit line 7 is violated.

7 LIMit 8 FAIL

This bit is set limit line 8 is violated.

8-14 These bits are not used

15 This bit is always 0

3.15.1.4 STATus:QUEStionable:PNOise Register

This contains information about phase noise measurements.

The bits can be queried with commands

STATus:QUEStionable:PNOise:CONDition?"

and

STATus:QUEStionable:PNOise[:EVENt]?"

Bit No Meaning

0 No traces are active

This bit is set when all the traces are switch off.

1 SIGNal not found

This bit is set if no valid signal is detected

2 VERify signal failed

This bit is set if verification failed to detect a signal within the supplied tolerances.

3 to 14 These bits are not used

15 This bit is always 0

3.16 Error Reporting

Error reporting for the K40 option is carried out using the Service Request (SRQ)

interrupt in the GPIB interface. When an error occurs a Service Request interrupt will

be generated. The master can then query the slave instrument for the error that

triggered the interrupt Errors are queried through the “SYSTem:ERRor” command.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 125 126

Keine Kommentare

Case K40 Spezifikationen Seite 119